[Buildroot] ARM allyespackageconfig report
Peter Korsgaard
jacmet at uclibc.org
Thu Mar 7 10:53:46 UTC 2013
>>>>> "Thomas" == Thomas Petazzoni <thomas.petazzoni at free-electrons.com> writes:
Thomas> Hello,
Thomas> I again did a build of an ARM allyespackageconfig configuration, with
Thomas> the Linaro 2013.01 toolchain. Results are not too bad:
Thomas> * I'm disabling jamvm and classpath because I don't have javac
Thomas> installed in the chroot I used to test Buildroot. Installing javac
Thomas> builds gazillions of dependencies, and since I want my chroot to
Thomas> remain as limited as possible in terms of number of distro packages,
Thomas> I don't want to installed javac. So definitely, those two packages
Thomas> have not been tested.
Thomas> * Besides those two packages that I disable ahead of time, only three
Thomas> packages failed to build: mplayer, ltp-testsuite and sconeserver.
Thomas> After disabling those 5 packages, the entire build went
Thomas> through. output/target/ weights 1023 MB, output/build/ weights
Thomas> 17 GB with a total number of 785324 files and directories. I
Thomas> don't have the overall build time though, since the build was
Thomas> interrupted 3 times due to the 3 failed packages.
Cool!
Thomas> mplayer build failure
Thomas> =====================
Thomas> {standard input}: Assembler messages:
Thomas> {standard input}:2857: Error: selected FPU does not support instruction -- `vmul.f32 q0,q0,q1'
Thomas> {standard input}:2951: Error: selected processor does not support ARM mode `veor q0,q0,q2'
Thomas> {standard input}:2952: Error: selected FPU does not support instruction -- `vmul.f32 q0,q0,q1'
Thomas> {standard input}:3023: Error: selected FPU does not support instruction -- `vmul.f32 d0,d0,d1'
Thomas> {standard input}:3106: Error: selected processor does not support ARM mode `veor d0,d0,d2'
Thomas> {standard input}:3107: Error: selected FPU does not support instruction -- `vmul.f32 d0,d0,d1'
Sounds like thumb2 / arm mismatch.
Thomas> ltp-testsuite build failure
Thomas> ===========================
Thomas> par_chld_ipv6.c: In function 'main':
Thomas> par_chld_ipv6.c:55:14: error: 'CLONE_NEWNS' undeclared (first use in this function)
Thomas> par_chld_ipv6.c:55:14: note: each undeclared identifier is reported only once for each function it appears in
Thomas> par_chld_ipv6.c:84:9: warning: implicit declaration of function 'unshare' [-Wimplicit-function-declaration]
Thomas> par_chld_ipv6.c:93:5: warning: implicit declaration of function 'crtchild' [-Wimplicit-function-declaration]
Thomas> two_children_ns.c: In function 'main':make[6]: *** [par_chld_ipv6.o] Error 1
Odd, do the Linaro guys build against old kernel headers (without
NEWNS/unshare)?
Thomas> sconeserver build failure
Thomas> =========================
Thomas> checking for InitializeMagick in -lMagick++... no
Thomas> configure: error: library 'Magick++' is required for Sconesite:image
Thomas> make[1]: *** [/home/test/outputs/allpkg/build/sconeserver-183/.stamp_configured] Error 1
Thomas> make: *** [all] Error 2
Could you have a look in config.log to see what goes wrong with the
InitializeMagick check?
--
Bye, Peter Korsgaard
More information about the buildroot
mailing list