[Buildroot] [PATCH v2 1/1] board: add support for RIoTboard
Thomas Petazzoni
thomas.petazzoni at free-electrons.com
Thu Mar 5 14:37:39 UTC 2015
Dear Nikolay Dimitrov,
On Thu, 5 Mar 2015 16:31:47 +0200, Nikolay Dimitrov wrote:
> +Create 2 partitions on the SD-card using your favourite tool. Partition 1
> +should be around 32MiB, partition 2 should be big enough to hold your rootfs,
> +for example 128MiB. Here's how an example of such partition layout:
> +
> + Device Boot Start End Blocks Id System
> +/dev/sdX1 2048 67583 32768 83 Linux
> +/dev/sdX2 67584 329727 131072 83 Linux
> +
> +Format these SD-card partitions with your favourite filesystem:
> +
> +sudo mkfs.ext2 /dev/sdX1
> +sudo mkfs.ext2 /dev/sdX2
> +
> +Copy the kernel, device tree and extlinux configuration to SD-card partition 1:
> +
> +sudo mkdir /mnt/sdcard/
> +sudo mount /dev/sdX1 /mnt/sdcard/
> +sudo mkdir -p /mnt/sdcard/boot/extlinux/
> +sudo cp -v board/embest/riotboard/extlinux.conf /mnt/sdcard/boot/extlinux/
> +sudo cp -v uImage /mnt/sdcard/boot/
> +sudo cp -v imx6dl-riotboard.dtb /mnt/sdcard/boot/
> +sudo umount /dev/sdX1
> +
> +Then deploy your rootfs on SD-card partition 2:
> +
> +sudo mount /dev/sdX2 /mnt/sdcard/
> +sudo tar xf rootfs.tar -C /mnt/sdcard/
> +sudo umount /dev/sdX2
Is there a particular reason to have two ext2 partitions? Why not one
single partition with the rootfs, also
containing /boot/extlinux/extlinux.conf, /boot/uImage
and /boot/imx6dl-riotboard.dtb ?
Best regards,
Thomas
--
Thomas Petazzoni, CTO, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
More information about the buildroot
mailing list