[Buildroot] [PATCH 2/4] board: raspberrypi: don't generate a marked kernel

[Yann E. MORIN]

Baruch, All,

On 2017-01-26 07:36 +0200, Baruch Siach spake thusly:
> We no longer use the marked kernel.
> 
> Cc: Peter Seiderer <ps.report at gmx.net>
> Signed-off-by: Baruch Siach <baruch at tkos.co.il>

Reviewed-by: "Yann E. MORIN" <yann.morin.1998 at free.fr>

Regards,
Yann E. MORIN.

> ---
>  board/raspberrypi/post-image.sh | 5 -----
>  board/raspberrypi/readme.txt    | 7 ++-----
>  2 files changed, 2 insertions(+), 10 deletions(-)
> 
> diff --git a/board/raspberrypi/post-image.sh b/board/raspberrypi/post-image.sh
> index c00975288c6f..b2bb07067835 100755
> --- a/board/raspberrypi/post-image.sh
> +++ b/board/raspberrypi/post-image.sh
> @@ -18,11 +18,6 @@ __EOF__
>  	;;
>  esac
>  
> -# Mark the kernel as DT-enabled
> -mkdir -p "${BINARIES_DIR}/kernel-marked"
> -${HOST_DIR}/usr/bin/mkknlimg "${BINARIES_DIR}/zImage" \
> -	"${BINARIES_DIR}/kernel-marked/zImage"
> -
>  rm -rf "${GENIMAGE_TMP}"
>  
>  genimage                           \
> diff --git a/board/raspberrypi/readme.txt b/board/raspberrypi/readme.txt
> index 03178ff95fa4..b6adca5151f6 100644
> --- a/board/raspberrypi/readme.txt
> +++ b/board/raspberrypi/readme.txt
> @@ -53,7 +53,6 @@ After building, you should obtain this tree:
>      +-- bcm2709-rpi-2-b.dtb         [1]
>      +-- bcm2710-rpi-3-b.dtb         [1]
>      +-- boot.vfat
> -    +-- kernel-marked/zImage        [2]
>      +-- rootfs.ext4
>      +-- rpi-firmware/
>      |   +-- bootcode.bin
> @@ -61,16 +60,14 @@ After building, you should obtain this tree:
>      |   +-- config.txt
>      |   +-- fixup.dat
>      |   +-- start.elf
> -    |   `-- overlays/               [3]
> +    |   `-- overlays/               [2]
>      +-- sdcard.img
>      `-- zImage
>  
>  [1] Not all of them will be present, depending on the RaspberryPi
>      model you are using.
>  
> -[2] This is the mkknlimg DT-marked kernel.
> -
> -[3] Only for the Raspberry Pi 3 Model (overlay pi3-miniuart-bt is needed
> +[2] Only for the Raspberry Pi 3 Model (overlay pi3-miniuart-bt is needed
>      to enable the RPi3 serial console otherwise occupied by the bluetooth
>      chip). Alternative would be to disable the serial console in cmdline.txt
>      and /etc/inittab.
> -- 
> 2.11.0
> 
> _______________________________________________
> buildroot mailing list
> buildroot at busybox.net
> http://lists.busybox.net/mailman/listinfo/buildroot

-- 
.-----------------.--------------------.------------------.--------------------.
|  Yann E. MORIN  | Real-Time Embedded | /"\ ASCII RIBBON | Erics' conspiracy: |
| +33 662 376 056 | Software  Designer | \ / CAMPAIGN     |  ___               |
| +33 223 225 172 `------------.-------:  X  AGAINST      |  \e/  There is no  |
| http://ymorin.is-a-geek.org/ | _/*\_ | / \ HTML MAIL    |   v   conspiracy.  |
'------------------------------^-------^------------------^--------------------'