[Buildroot] [PATCH] busybox: disable PAM in the config if linux-pam is not selected
Peter Korsgaard
peter at korsgaard.com
Mon Mar 26 12:51:32 UTC 2018
>>>>> "Arnout" == Arnout Vandecappelle (Essensium/Mind) <arnout at mind.be> writes:
> Currently there is only logic to enable PAM when linux-pam is selected.
> However, busybox will fail to build with PAM enabled if the linux-pam
> package has not been built before. So we should forcibly disable PAM in
> busybox in that case.
> Normally this is not an issue since our default busybox config doesn't
> have PAM enabled. However, if you enable linux-pam, then save the
> busybox config to a custom configuration file, then disable linux-pam
> again, and then do a "make clean; make", the build will fail. A more
> practical situation where this can occur is when the same custom
> busybox config is used in a Buildroot config with and without
> linux-pam.
> Signed-off-by: Arnout Vandecappelle (Essensium/Mind) <arnout at mind.be>
> ---
> Resend, patchwork missed the first send.
Committed, thanks.
--
Bye, Peter Korsgaard
More information about the buildroot
mailing list