[Buildroot] [git commit] board/raspberrypi/readme.txt: add note for bootcode.bin

[Julien Olivain]

commit: https://git.buildroot.net/buildroot/commit/?id=c7ea55f040b6d74314961e433c3879ef1ac61748
branch: https://git.buildroot.net/buildroot/commit/?id=refs/heads/master

The second-stage bootloader is contained in the onboard EEPROM[1] since
the Raspberry Pi 4 (i.e. for pi4, pi400, cm4, cm4s and pi5).

Therefore, the file bootcode.bin[2] is needed for the former Raspberry
Pi only (i.e. pi1, pi2, pi3, pi0, pi0w and pizero2w).

This adds a note precising the file bootcode.bin is present for the
former versions of the Raspberry Pi.

[1]: https://www.raspberrypi.com/documentation/computers/raspberry-pi.html#raspberry-pi-boot-eeprom
[2]: https://www.raspberrypi.com/documentation/computers/configuration.html#bootcode-bin

Signed-off-by: Gaël PORTAY <gael.portay+rtone at gmail.com>
Signed-off-by: Julien Olivain <ju.o at free.fr>
---
 board/raspberrypi/readme.txt | 10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)

diff --git a/board/raspberrypi/readme.txt b/board/raspberrypi/readme.txt
index 64f0e2a26f..5f6b1c3e7d 100644
--- a/board/raspberrypi/readme.txt
+++ b/board/raspberrypi/readme.txt
@@ -112,14 +112,14 @@ After building, you should obtain this tree:
     +-- boot.vfat
     +-- rootfs.ext4
     +-- rpi-firmware/
-    |   +-- bootcode.bin
+    |   +-- bootcode.bin            [2]
     |   +-- cmdline.txt
     |   +-- config.txt
     |   +-- fixup.dat               [1]
     |   +-- fixup4.dat              [1]
     |   +-- start.elf               [1]
     |   +-- start4.elf              [1]
-    |   `-- overlays/               [2]
+    |   `-- overlays/               [3]
     +-- sdcard.img
     +-- Image                       [1]
     `-- zImage                      [1]
@@ -127,7 +127,11 @@ After building, you should obtain this tree:
 [1] Not all of them will be present, depending on the RaspberryPi
     model you are using.
 
-[2] Only for the Raspberry Pi 3/4 Models (overlay miniuart-bt is needed
+[2] Only for the Raspberry Pi 1, 2, 3, Zero, Zero W and Zero 2 W. The Raspberry
+    Pi 4, 400, 5 and the Compute Module 4, 4s and 5 load the second stage
+    bootloader from a SPI flash EEPROM.
+
+[3] Only for the Raspberry Pi 3/4 Models (overlay miniuart-bt is needed
     to enable the RPi3 serial console otherwise occupied by the bluetooth
     chip). Alternative would be to disable the serial console in cmdline.txt
     and /etc/inittab.